More Views


Availability: In stock

Fits the following Ubiquiti radios:
PBE-5AC-500 - PowerBeam 5AC

NOTE: Radio/Antenna NOT included.

WARNING: Same cost to ship this single as a 5 PACK.



Reduce unwanted RF energy from the back, sides, top, and bottom outside the designed beam from reaching the antenna and radio keeping the radio focused on the intended signal.
Co locate several radios close together with out self interference and a much lower noise floor!
Increased performance and throughput.
The kit will NOT increase the gain of the antenna, however it will lower the noise floor providing a much cleaner signal allowing for higher sustainable air rates.
Made from marine grade aluminum.
Additional Information

Additional Information

Manufacturer RF Armor
Country of Manufacture United States

Customer Reviews 1 item(s)

Amazing product.
Having to connect two residences approximate 3/5 of a mile from each other through minimal bushes/trees, I found that a 5.8 ghz link using a Nanostation M5 on one end and a Nanobridge M5 on the other actually linked up, but didn't have the best signal strength. I've browsed the forums for a while and always saw the RF Armor product, but didn't attempt to try it until now. I purchased one kit for the Nanobridge end, and the results were hard to believe at first. Signals went from an average of -72 before the install to a -54 afterwards. I'm and believer and have just ordered 5 more kits.
Review by Bobby Lacey / (Posted on 6/27/2015)