Welcome

UNBK25

More Views

UNBK25
$49.95

Availability: In stock

Fits the following Ubiquiti radios:
PBE-5AC-GEN2 - 400mm / 420mm
PBE-5AC-400
PBE-M5-400
NBE-M2-400 - NanoBeam M2-22
NBE-M5-400 - NanoBeam M5-25
NB-2G18-400 - NanoBeam M2-18
NB-5G25-400 - NanoBeam M5-25


NOTE: Radio/Antenna NOT included.


WARNING: Same cost to ship this single as a 5 PACK.

Description

Details

Reduce unwanted RF energy from the back, sides, top, and bottom outside the designed beam from reaching the antenna and radio keeping the radio focused on the intended signal.
 
Co locate several radios close together with out self interference and a much lower noise floor!
 
Increased performance and throughput.
 
The kit will NOT increase the gain of the antenna, however it will lower the noise floor providing a much cleaner signal allowing for higher sustainable air rates.
 
Made from marine grade aluminum.
Additional Information

Additional Information

Manufacturer RF Armor
Country of Manufacture United States
Reviews

Customer Reviews 3 item(s)

If you are considering the use of the RF Armor products the only thing I can tell you is that we should have all done it long ago and having a site without it is a mistake.
I have been a WISP since 2007 and in the last year have implemented the use of RF Armor Shielding at all of my relay and tower sites. I have found that the use of their product has allowed me to make 40% more use out of the license free spectrum by reducing outside noise and interference from other sites. In addition to providing more efficient spectrum use, I have also noticed higher and more stable over the air data throughput.
I have found the design and engineering to be of the highest quality and the ease of application well thought out.

Eric Williams (W7EMW)
SDWISP Network Administrator
Value
Quality
Price
Review by Eric Williams / (Posted on 6/27/2015)
Amazing product.
Having to connect two residences approximate 3/5 of a mile from each other through minimal bushes/trees, I found that a 5.8 ghz link using a Nanostation M5 on one end and a Nanobridge M5 on the other actually linked up, but didn't have the best signal strength. I've browsed the forums for a while and always saw the RF Armor product, but didn't attempt to try it until now. I purchased one kit for the Nanobridge end, and the results were hard to believe at first. Signals went from an average of -72 before the install to a -54 afterwards. I'm and believer and have just ordered 5 more kits.
Value
Quality
Price
Review by Bobby Lacey / (Posted on 6/27/2015)
It's really amazing how much these help reduce the noise.
To boot I believe the shield helped save one of our radios from a direct lightning strike on one of our towers. Every other radio died, but the nanobridge is still trucking along.
Value
Quality
Price
Review by Lance Laughter / (Posted on 6/27/2015)